Waterpik Portable WP560 Battery Replacement Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacing the batteries in WP560 Portable WaterPik requires a careful destructive removal of the battery (and motor)…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 16
- Makes
- 0
- Views
- 200
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
Replacing the batteries in WP560 Portable WaterPik requires a careful destructive removal of the battery (and motor) case bottom to get access to the batteries. This part is a battery door or bottom to use for re-assembly.
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 5
Rafts:
No
Supports:
Yes
Resolution:
0.25 mm
Infill:
100%
Filament: Any PLA White Post-Printing =============
How to replace the batteries
You need to take the unit apart - there is a Youtube https://www.youtube.com/watch?v=yTbf-R2FCRc that explains it (but use a guitar pick under the top ring and press in the "latches" to get the top ring off). That video stops short of openning the battery bottom. Basically a sturdy knife to separate at the corners and then cut into the bottom in the center and small pliers to pull the pieces out. You can then access the batteries. The original door is glued in at the edges. Either cut the red motor to battery wire at the battery will allow removal of the batteries (or the harder to reach and re-attach de-solder at the motor).
You will need 4 screws with pan heads that are < 75 thou high. Alternatively you could glue it back on.I also put some sealant around the edge of the door before inserting.
You will also need 2 AA NiMh batteries with tabs. The originals in the unit I repaired were 1300 mAh - I replaced with an upgrade to 2300 mAh.
Category: Bathroom