Keychron V1 Slide On Magnetic Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A very slim case for the Keychron V1 Keyboard with press fit magnets.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 48
- Makes
- 0
- Views
- 416
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a slide on transport case for the Keychron V1 (Knob and non-Knob). Inspired by a case for the Logitech MX Master 3(S) https://www.printables.com/model/213059-logitech-mx-master-3-case
The case is very slim and light. All outer casing is ca. 1.6mm (4 shells) thin, the bottom is also 1.6mm high.
My print used 275g PLA at 0.24 Layer Height. Make sure to set the bottom/top shells to a 5 and the outer shells to 3 no not have some tiny infilled layers. This print uses 8 5x3 round magnets. They should be press fit, no glue required, make sure to get the orientation right. The magnets can be pressed in a little bit more so if closed the magnets do not have contact with each other, this will result in a perfectly closed case. To get this, take a spare magnet, put it on to the already inserted magnet, and press again on the desk, as seen in the last image.
Happy Printing and typing!