Big Money (piggy bank)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A dollar symbol you can watch fill up with your coins
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 46
- Makes
- 0
- Views
- 421
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Big Money!

File Selection
A full print will consist of two parts, the “Base” and the “Symbol".
For the “Symbol” you can choose to print the file as-is but it won't have the hexagons. If you want it to look like the photo, you can either use the 3MF (highly recommended) or follow the instructions below.
Printing
As mentioned above, to get the hexagon effect and color changes the easiest way is to import the 3MF into PrusaSlicer. Otherwise follow the instructions below
General Settings and Printing
- The symbol should be front-face down on the bed (as imported).
- This is important for bridging and getting the hexagons on the front-side of the model
- 0.2mm layer height
- I used a brim to avoid warping
- Use 4 perimeters
- this helps enable the bridging described below
- Print without supports (this is possible due to bridge helpers and changing the Bridging angle)
- Also, they would be really hard to remove :)
Setting the Bridging angle
Set the Bridging angle setting (under “Print Settings" > "Infill”) such that the first bridge layer (@ 31.80mm) is roughly 45 degrees from the bridge helpers (small lines) on the layer below. (See the image below for what this looks like.) The goal is to get the shortest possible bridges that are roughly perpendicular to the bridge helpers.

For my bed I had the model at roughly 45 degrees which meant I needed to set my Bridging angle to 90 degrees.
As imported (sideways to the bed) the Bridging angle should be 45 degrees
Adding the Modifiers to Get Hexagon Effect (if you are not using the 3MF)
- Import the Symbol STL file into PrusaSlicer and orient it on your print bed
- Add a modifier slab
- Right click on the model > Select “Add modifier” > Select “Slab”
- Resize the slab to be 2.6mm thick (you may need to click the little lock icon to disable scaling the X and Y at the same time)

- Make sure the slab is sitting on the print bed (some times it tries to levitate part way up the model). There is a little button above the Z position that will let you drop it to the bed.

- Position and scale the slab to cover the whole model

- Add the following settings to the slab
- Fill density: 10%
- Fill pattern: Honeycomb
- Bottom solid layers: 0
- Top solid layers: 0
