Mario Themed Reptile Hide
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mario themed reptile hide intended for a terrarium
- Rating
- 5 / 5
- Likes
- 198
- Downloads
- 404
- Makes
- 1
- Views
- 4,040
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial
Information
Included are models for a mario warp pipe with 4 lower exits and a staircase of standard block tiles found on 1-1 and other levels. The warp pipe and the block staircase connect to eachother through the circular openings on each model.
Scaling
There are two sets of models included, one with thicker walls and one with thin walls. The thin wall model is intended to conserve filament and print at 100% scale for larger critters. These were the models I used for my terrarium and lizard. The thicker wall models can be scaled down safely (~50% lowest recommended) for smaller critters and still retain structural integrity.
Warp Pipe Cap
Included is a model for a cap to be used with the lower warp pipe exits in case there are some left unconnected and your critter prefers some privacy.
Print Settings
Infill
I recommend using 5-10% infill if you want to conserve filament. I used 5%.
Supports
Supports should be used for both the warp pipe and block staircase. I used 5 degree overhang for the block staircases and 10 degree overhang for the warp pipe.
Brim/Raft
I used a 3mm brim to ensure my model would not move off the print bed 20 hours in.