Steps for Tacx Galaxia Rollers - Indoor Bicycle Aid
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Steps for easily mounting and dismounting your bicycle on Tacx™ Galaxia rollers.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 37
- Makes
- 0
- Views
- 598
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Indoor Sports
- License
- BSD License
It can be challenging to mount and dismount a bike when it's on the dynamometer, so here's my solution. It's a pair of steps to mount on the side rails of a set of Tacx™ Galaxia rollers. These steps will allow the rider to mount and dismount his bicycle just as easily as if it were on the ground. As opposed to having to leap several extra inches.
Manufacture
A build volume of at least 110x180x185mm is required. I'm printing on a modified Prusa Mini+.
Print two steps: one left and one right. The settings that I consider important are:
- Perimeters: 3mm total thickness
- Minimum shell thickness: 3mm top, 2mm bottom
- Infill extrusion width: 1.2mm
- Infill pattern: Honeycomb
- Infill density: 8%
For reinforcement, pound a 190mm segment of coat-hanger wire into each of the two cylindrical holes in each step, and glue the ends.
Installation
Disconnect the front end of the roller unit from the rear. Slide one step onto each of the two side rails of the front end, positioning it so the overhangs are rearward and inward. Then reassemble the roller unit.