1 / 5
Star Wars Galactic Republic Logo Magnet
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
You can glue a 10 x 1.5 mm round magnet in the base.
- Rating
- 0 / 5
- Likes
- 38
- Downloads
- 202
- Makes
- 1
- Views
- 830
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
You can glue a 10 x 1.5 mm round magnet in the base.
Print instructions
Recommended infill angle: 0°
Alternative top infill pattern: Archimedean Chords
Low speed and high temperature will create a shiny top surface.
There are "holes" inside the model to make some of the top layers more uniform, and they were created with 0.2 layer height in mind.
If your top surface is not flat & shiny and you see scarring, then make sure to check this guide: https://bit.ly/2UtN0I1