1 / 12
Nikko Lobo 2 Front A-Arm 1:14 R/C Buggy
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These fit the 1/14 Scale Nikko Lobo 2 / Sears Lobo II R/C Buggy.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 45
- Makes
- 0
- Views
- 399
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Nikko Lobo 2 ( Sears Lobo II 7.2v) Front Suspension Arms
These are the Front A-Arms for the Sears Lobo II made by NIKKO. They fit other Nikko 1/14 Scale buggies that use the same chassis. PLA is fine for display or a quick run around the yard, but something stronger would be advised for long term use.
- Removal: The pivot pin nut is pressed on. To remove, I put it in a vice and used a smaller diameter pin to drive it out with a hammer. The pivot pin is 4mm, so I used a 3mm pin. You can use an Hex / Allen Key or similar.
- Install: Place the opposite side on something solid, and hammer away. ;)
- I think these only fit the Lobo 2. The one that takes 7.2v NiCad Pack and is 1/14 Scale.
- NOT for Nikko Lobo Black Fox, which take AA Batteries. They look similar, but the front Arms are not the same.
- Also Not for Nikko 1/10 Scale F10 Buggies.