1 / 2
Parametric IDC Connector Cover for 10-pin and 16-pin Shrouded Eurorack Header — image 1
1 / 2

Parametric IDC Connector Cover for 10-pin and 16-pin Shrouded Eurorack Header

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Plug for unused IDC connectors to prevent accidental short-circuits on modular synthesizer power rails.

Rating
5 / 5
Likes
25
Downloads
207
Makes
1
Views
1,330
Reviews
2

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Eurorack synths use busboards with IDC power headers to distribute power across a system. If there's any risk a patchcable could come into contact with them and short pins, those little caps might grant you a sense of relief during your more agitated patching sessions. Normally you'd solve the problem with blank plates instead, but punk-ass DIY builds don't do normal.

Print without supports in the default orientation. The size might be a bit tight for a good grip, especially if your z-offset is poorly tuned: after printing, it might be a good idea to blast the bottom of the print with a heat gun for a few seconds then immediately fasten it to a connector. It will ensure the holes are a perfect fit. Just make a test print before you do a large batch.

I tested only the 10-pin and 16-pin versions, the sizes used for synths. Using OpenSCAD, you can change the size of the holes, and make any other variant such as 12-pin or 69420-pin (the datasheets say the dimensions will work out).

Low-budget materials such as PLA or PETG are not conductive to any meaningful extent. However, some filaments add a bit of metal or graphite to their mix to achieve a metal finish, decreasing their resistance. If in doubt, just verify your material is a good insulator with a multimeter in ohmmeter mode.

I waive all liability if my print causes your €3000000000 synth to explode.

Tags