1 / 4
HX711 Load Cell Digital Display Box - 18650 and USB-C
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Box for a HX711 Load cell display module with 18650 battery, switch, and PG7 strain relief.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 77
- Makes
- 0
- Views
- 689
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
HX711 load cell display module box with battery and charging module.
Assembly Notes/etc:
- The cover interferes with the charging board, just cut the lip away where it touches. It was easier to modify than measure and place in CAD for a one off.
- Charging board needs to be glued in.
- There's a thin spot for the charging board light. I drilled it out (2mm) and attempted to squirt some hot glue in it to make a light pipe effect. It didnt work.
- The seam is line on line, so you may need to do a bit of filing on the lip of the cover depending on how much your printer overextrudes.