Creality K1 BLTouch Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The model allows you to install the BLTouch on a standard CRTouch mount
- Rating
- 5 / 5
- Likes
- 97
- Downloads
- 469
- Makes
- 3
- Views
- 4,990
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I had problems with the native load cells, so I decided to use the BLTouch. This adapter allows you to install your BLTouch into the CRTouch mounting position on the rear of the K1 and K1 max carriage.
Among other things, you will need 2 M3 screws 5-6 mm long and two AISI 304 self-tapping screws (2.2 x 9.5 mm).
Print with the letters "UP" facing up.)
You may need to remove the [prtouch_v2] and [prtouch_v2_fan] sections, otherwise you will get an error that the BLTouchWrapper does not contain the "set_fan_speed" attribute.
Below are the settings for Creality K1:
[bltouch]
sensor_pin: nozzle_mcu: PA9
control_pin: nozzle_mcu: PA8
pin_move_time: 0.680
x_offset: 0.0
y_offset: 25.25
z_offset: 1.925
speed: 5
samples: 3
lift_speed: 20
probe_with_touch_mode: false
samples_result: average
stow_on_each_sample: false
samples_tolerance: .1
samples_tolerance_retries: 4[bed_mesh]
speed: 500
horizontal_move_z: 8
mesh_min: 5,30
mesh_max: 210,209
probe_count: 12,12
algorithm: bicubic
bicubic_tension: 0.1