Ford Bumpside Tail Light Lens

Tail light lens replacement (with alterations) for 1967-1972 Ford F-Series Trucks and 1967-1968 Mercury M-Series Trucks.

I recommend printing with transparent/translucent PETG (red and clear), 0.18 mm layer height, 22% Sprial infill, one bottom layer, 2/3 top layers, and supports only for the base part. Glue together.

If you have an X1C or an X1E I also recommend telling the printer it has a 0.6 nozzle without actually replacing the 0.4, and then letting it do the self-extrusion calibration, it creates a really cool effect.

Liability Waiver:

By downloading the provided 3D files for non-DOT/non-SAE replacement taillight lenses, you acknowledge and agree to the following terms and conditions:

Assumption of Risk: These 3D files are intended for non-DOT/non-SAE purposes and may not meet required safety standards. You assume all risks associated with using and installing taillight lenses created from these files.

Compliance Acknowledgment: Taillight lenses created from these files may not comply with DOT or SAE safety standards and might not be road-legal. Their use may be prohibited by law.

Release of Liability: You release the provider and its affiliates from any claims, damages, or liabilities arising from the use of these 3D files or resulting taillight lenses.

Indemnification: You agree to indemnify the provider against any claims, losses, or damages arising from your use of these 3D files.

Legal Responsibility: It is your sole responsibility to ensure compliance with all applicable laws before using taillight lenses created from these 3D files.

No Warranty: The provider offers no warranties regarding the accuracy or suitability of these 3D files for any specific purpose.

Legal Jurisdiction: Disputes shall be governed by the laws of [Your State/Country], and legal action shall be under the jurisdiction of courts in [Your State/Country].

By downloading these 3D files, you affirm that you have read and understand this waiver and agree to its terms and conditions.