70mm EDF thrust tube (fits Dr. Mad Thrust Alloy EDF)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a thrust tube for a Dr. Mad Thrust 70mm EDF and designed for high speeds
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 284
- Makes
- 0
- Views
- 3,743
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
This is a thrust tube for a Dr. Mad Thrust 70mm EDF and designed for high speedsot an aerospace engineer, but i tried to design it as good as possible, and after schübeler's description on their website: http://www.schuebeler-jets.de/en/edf-know-how-en/configuration-of-the-channels)
Printing:
Print the tube and the wire-fairing upright, gives you the best result.
I printed the thrust tube with Hobbyking PLA at 0.2mm layer resolution and with 100% infill
(weight: ~70g).
You should be fine with approx. 15% infill and 0.4 mm walls (looks like it should print just fine with triangular infill) and you should end up with a weight of approx. 40g.
Post-Printing
Mounting of the wire-fairing
Mount the thrust tube to your EDF and put the wires through the hole.
Then slip the fairing over the motor wires and glue it into place with a few drops of CA. **trimming of mounting tabs**
You might have to trim down the mounting tabs on the sides, so they don't interfere with the ones mounted on your EDF.
Smoothing of the inner surface (not necessary)
You could try to sand down the inner part of the tube to get a bit higher efficiency out of it as the print isn't 100% smooth (I use my thrust tubes straight from the printer and didn't notice any loss of power on my models, but I also didn't make any scientific tests of any kind).