Little Boy Brew - Pocket Launcher
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small but mighty launcher, that will comfortably fit in your pocket. Perfect for office warfare or plinking cans!
- Rating
- 4.8 / 5
- Likes
- 276
- Downloads
- 466
- Makes
- 3
- Views
- 10,893
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
The “Little Boy Brew” is a cool little pocket launcher that uses a two part projectile consisting of a casing and bullet! Can shoot over 20 feet with a little bit of an upwards angle. This is quite powerful at close range so you appropriate caution when firing.
Simple to print and build! Only requires a few extra pieces' of easy to find hardware. Please enjoy safely!
Print Settings:
Material: PLA, PLA+, PETG
Walls/Top/Bottom: 4+
Infill: 15% or more.
Supports: Only required for the frame (Regular supports recommended)
Hardware:
3 x M3*15 Bolts
2 x M3*10 Bolts
1 x M3*20 Bolt
3 x M3 Nuts
1 x Pen Spring (Cut in half - One half for barrel latch, other half for the striker latch.
1 x Striker Spring - OD: 9.5 mm, ID: 8mm, WD: 0.8, Free Length: 46mm
- There is a bit of wiggle room with useable spring dimensions, just make sure the outer diameter is no bigger than 10mm and that the length is between 45-50mm. It should also be no longer than 5 mm when fully compressed.