1 / 3
Fluval 307/407 Canister Filter Shrimp and Fry Inlet Guard Strainer — image 1
1 / 3

Fluval 307/407 Canister Filter Shrimp and Fry Inlet Guard Strainer

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement intake strainer to prevent filter from sucking up shrimp and small fish.

Rating
5 / 5
Likes
42
Downloads
652
Makes
2
Views
2,613
Reviews
2

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial — Share Alike

Didn't fine any eligent solutions to this problem that retained the ball check valve used for priming the filter. So I made one.

1.5mm holes

Print with ABS or PETG. I tested both. Settled on ABS as it looked nicer. Pictured is the PETG version. Both seem to be quite strong. Was not able to break it by crushing it with thumb and index finger.

May need to scale the print in the slicer to 99-101% to get a snug fit depending on your printer.

Tested for a month. Found no shrimp in filter with over 200 in the tank.  They are almost always on the strainer eating off it. I would keep the intake away from anything that might have baby shrimp hiding in it. Strainer did not restrict flow or clog easily. Definitively don't need to clean it as often as a sponge pre-filter. While testing filter was at 100% flow.

According to the Fluval website this will fit the following filters.

305/405 Canister Filter

306/406 Canister Filter

307/407 Canister Filter

Someone with a little bit of CAD experience should be able to modify this to fit the other models by making either an adapter ring or making the attachment point smaller. Scaling the part might work but it could make the holes too small.

 

Tags