Crying Girl (1963) Roy Lichtenstein
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.64 – €4.45 net (excluding VAT)
For file: LichtenstienCryingGirl1963No9_0.4n_0.2mm_PLA_MINIIS_2h59m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.05 excluding VAT (range midpoint).
- Weight reported by the author
- 73 g
- Print time reported by the author
- 2.98 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
a 4 color multilayered print that is sliced into 12 tiles to fit on a mini and yet end up life size.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 55
- Makes
- 0
- Views
- 410
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial
This was almost impossible for me to figure out how to do and streatched my abilities to the limits. It will likely torture your printer and it shouldnt be attempted unless you have it dialed in enough to minimize stringing. I've set up the project file for a mini, and included the full STL as well as the stl for each color so you can decide what to do with it and decorate as you wish. the original artwork measured 16"x24" but I think the picture I was working off of got slightly cropped so this will be closer to 16"x22"ish if printed full size. Of course you could go bigger. I wouldn't scale it down much though because the zillions of red dots might not print well if it gets much smaller than say 66% scale.
If you're having trouble with printing, the stl files for each tile are here too and they might need a little cleaning up in order to avoid some print errors. Tiles are assembled as follows
1 2 3 4
5 6 7 8
9 10 11 12
Start by printing white then change to yellow then red then black
The process I used involved separating the original artwork into its 4 separite colors and then turning the layer masks into svg vector graphics that could then be turned into an stl. The svg files ended up being too complex for prusaslicer or tinkercad to handle so https://svg2stl.com saved the day. After downloading the resulting stl files prusaslicer was able to align and reassemble the colors into one file