Enclosure for Sparkfun's Openscale and 1kg - 20kg Strain Gauge Load Cell
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an enclosure (bottom, top, feet) for the Sparkfun's Openscale and also a plate for the load cell.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 129
- Makes
- 0
- Views
- 843
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This is an enclosure (bottom, top, feet) for the Sparkfun's Openscale and also a plate for the load cell. It should work with the strain gauge load cells from uXcell, Sparkfun, and Adafruit; 80mm x 12.7mm x 12.7mm (note that Adafruit's documentation lists it as 75mm x 12.7mm x 12.7mm). The load cell's mounting holes use M4 mounting hardware.
The recommended assembly is as follows:
1) Attach Openscale to base using M2.5 screws - a washer could be used between Openscale and base's standoffs.
2) Connect Openscale to strain gage wires.
3) Attach top plate to strain gage (using M5 screws) - spacer must be used between plate and gage.
4) Attach strain gage to base - spacer must be used between base and gage.
5) Attach top plate to complete enclosure using M2.5 screws.
6) Attach feet to bottom of base - use bit of glue to attach.
Project Page → https://github.com/ElTopollillo1990/openScaleProject
References:
- SparkFun OpenScale - SEN-13261 - SparkFun Electronics
- Load Cell - 10kg, Straight Bar (TAL220) - SEN-13329 - SparkFun Electronics
- Strain Gauge Load Cell - 4 Wires [Various Weights] : ID 4630 : $3.95 : Adafruit Industries, Unique & fun DIY electronics and kits
- Amazon.com: uxcell 20kg Weighing Electronic Balance Wired Load Cell Weighing Sensor for Kitchen Scale,Human Body Bathroom Scale, Jewelry Scale : Office Products