1 / 5
electric skateboard pulley adapter - 37T to 45T / 44T — image 1
1 / 5

electric skateboard pulley adapter - 37T to 45T / 44T

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A 37T to 45T adapter for electric skateboard (or any HDT 5M) pulleys, not tested (yet)

Rating
0 / 5
Likes
6
Downloads
60
Makes
1
Views
662
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

This is a 37T to 44T adapter for electric skateboard pulleys!

designed for the Backfire cloudwheel pulleys, but it works on any 37T HDT 5M pulley

A few considerations:
  • The STL has 0.5mm clearance, at first it might feel quite stiff but after a bit of putting it on and pulling it off it should wear in. This was done because… you don't want it to come off easily ;)
  • Make sure your elephant foot compensation is dialed in! you don't want it to not insert completely!
  • I have used them on my eskate for a few hundred km now with absolutely no issue. Regardless, USE IT AT YOUR OWN RISK! It's clearly dangerous!
  • it's PLA so it's gonna wear down faster than normal pulley material, it still shouldn't be a huge problem as it just takes a few hours to reprint and replace it. If you have better materials, feel free to test and tell us in the comments!
  • if you want to try it, you have to print it slow, hot, with many perimeters and with an infill of ~65%, as it was tested to be stronger than 100%.
  • you're gonna need bigger belts for this. I don't know exactly how big, if you know, tell me! It's gonna be a bit of a challenge to find the right length belts if your eskate has non-adjustable motor mounts, so be aware that you might have to do some trial and error.
  • there's a spacer you can print, to align things if your belt rubs on the adapter.

There are two versions of it, one with a ring so that the belt doesn't rub against the wheel, and one without. I use the one with the ring. There's also a 35T to 40T model, for somebody on Thingiverse :)

SETTINGS SUMMARY:

Rafts: No

Supports: No

Infill: ≥60%, <80%

Filament: any strong PLA, or tougher material.

 
IMPORTANT:
  • Make sure your elephant foot compensation is dialed in! you don't want it to not insert completely!
  • if you want to try it, you have to print it slow, hot, with many perimeters and with an infill of ~65%, as it was tested to be stronger than 100%.

Tags