1 / 9
Clepsydre - Water Hourglass
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use water and air pressure to measure 1 minute.
- Rating
- 5 / 5
- Likes
- 59
- Downloads
- 137
- Makes
- 1
- Views
- 1,770
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution
A clepsydre is an hourglass that uses water instead of sand.
You will need to add water into the clepsydre before the end of the print.
- First Print an “Infill Cup” file - You will need it to have the exact amount of water (if you add too much water, the clepsydre will not work)
- Then print the Clepsydre
- Add a pause in your slicer at z=114mm (before it starts closing the top)
- Fill the clepsydre with water - Use your Infill Cup (water up to the top line)
- Finish the print
To start the clepsydre :
- Return the clepsydre (water in the top)
- Shake the clepsydre once
Print Settings :
- Printed on MK3S
- Filament tested : PLA
- Nozzle 0.4mm : 0.20mm tested
- Brim : 5mm
- Perimeters : 4
- Solid Layers : Top 6 - Bottom 5
- Infill : Concentric 20%