Kel Tech Sub 2000 Charger Two Finger Pull
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a dual finger charger pull for a Kel Tech Sub 2000. The stock one is thin and hurts my finger while pulling.
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 110
- Makes
- 1
- Views
- 525
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This is a dual finger charger pull for a Kel Tech Sub 2000. The stock one is thin and hurts my finger while pulling. This can be glued around (trying to figure out a good mounting solution that can be more easily removed) the charger and makes it thicker.
I used 95A TPU and that is soft enough for comfort and strong enough not to break if you just pull on the bottom half which isn't supported by the stock charger.
Print Settings
Printer Brand:
AnkerMake
Printer:
AnkerMake M5
Rafts:
No
Supports:
No
Infill:
30
Filament:
Any TPU or PETGAny
Category: Parts