Hacksmith Mini-Saber Gen2 Lochwand Halterung | Hacksmith Mini-Saber Gen2 Pegboard Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hacksmith Mini-Saber Gen2 Lochwand Halterung | Hacksmith Mini-Saber Gen2 Pegboard Mount
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 23
- Makes
- 0
- Views
- 513
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
[Deutsch - German]
Du hast gerade dein neues Hacksmith Mini-Saber Gen. 2 erhalten und möchtest es nun ansprechend an deiner Lochwand präsentieren? Dann ist dieser Print die Lösung.
Die Halterung nimmt das Hacksmith Mini-Saber Gen. 2 auf.
Die Halterung passt an eine Lochwand mit 45 mm Lochabstand.
Zur Montage werden zwei 4 mm Schrauben mit entsprechenden Muttern benötigt.
Der Druck wurde mit der flachen Seite (Lochwandseite) auf dem Druckbett mit einem Prusa MK3S ( 0,2mm Qualität, kein Support, 15% infill ) durchgeführt. Es gab etwas Stringing im Schraubkanal aber das stört nicht.
[Englisch - English]
Have you just received your new Hacksmith Mini-Saber Gen. 2 and want to display it attractively on your pegboard? Then this print is the solution.
The mount accommodates the Hacksmith Mini-Saber Gen. 2.
The mount fits a pegboard with a 45 mm hole spacing.
For assembly, two 4 mm screws with corresponding nuts are required.
The print was done with the flat side (pegboard side) on the print bed of a Prusa MK3S (0.2mm quality, no support, 15% infill). There was some stringing in the screw channel, but it's not a problem.