LayersFactory
Report model
1 / 6
Kitchen Sink Stopper — image 1
1 / 6

Kitchen Sink Stopper

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

JPM Designs

JPM Designs

@Jamz58

Two versions available. Designed to fit stainless steel kitchen sink. These exit the cover at about 78.5mm at an angle.

Rating
0 / 5
Likes
16
Downloads
125
Makes
0
Views
445
Reviews
0

Updated at source:

Model information

Source
Printables
Category
Kitchen
License
Creative Commons — Attribution — Share Alike
DetailsFiles (3)Makes & comments (Makes: 0) (Comments: 0)Remixes (0)Collections (14)Related

PLA stoppers need to be printed with 100% fill and should be somewhat loose if you use in hot water. V1 originally didn't have a cover and it couldn't be pulled out until the water cooled down. In cool/lukewarm water V1 Part 1 is fine all by itself. Super glue needed for V1 assembly.

Caution: PLA floats if less than 80% fill. Can't stop much if its floating. 😀

Print V1 P1 with knob up and P2 with cavity up. Print V2 with top side down. No supports needed.

Tags

kitchenstopstoppersinkdrainkitchensinksinkstopperdrainplugsinkstop