1 / 6
Confetti Pea Shooter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Spring Powered Confetti Pea for all of your small projectile launching needs.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 351
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Winter & Christmas & New Year's
- License
- Creative Commons — Public Domain
Ever wondered what to do with all of those scarps from your print brims? Have a Pen Spring, a M3x 50 Bolt, and an M3 Nut? Then howdy do I have design for you. This Spring Powered Confetti Pea Shooter was inspired by New Years Party Crackers and gives you a way to make a whole new mess with your print scraps.
Assembly Instructions:
Print One each of the Following Parts:
- Barrel @ no less than 15% In-Fill
- Barrel Cap @ no less than 25% In-Fill
- Plunger Face @ no less than 15% In-Fill
- Pinch @ no less than 25% In-Fill
Gather One each of the Following Parts
- M3 x 50mm Bolt
- M3 Nut
- Standard Pen Spring
Assembly Steps
- Slide the Pinch over the M3 Bolt to create the Plunger Handle Sub-Assembly.
- Insert the M3 Nut into the Plunger Face.
- Insert the Plunger Handle Sub-Assembly into the Barrel from the Bottom.
- While holding the pieces vertically, slide the Pen Spring over the tip of the M3 Bolt on inside of the Barrel.
- With an Allen wrench in place on the Plunger Handle Sub-Assembly, hold the barrel vertically. Then slide the plunger face straight down into the barrel, depressing the spring as you do so, aligning the Plunger Handle Sub-Assembly, Pen Spring, & Plunger Face.
- Tighten the M3 Bolt until the tip is flush with the Plunger
- Place Barrel Cap on Barrel
- Fin