Sovol SV06 Plus mainboard extruder cable support (remix)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mainboard extruder cable support for the Sovol SV06 and SV06 Plus
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 189
- Makes
- 6
- Views
- 738
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Keep your Sovol SV06 or SV06 Plus extruder cable elevated with this cable support! This remixes itsrouteburn's Sovol SV06 Plus Print Head Cable Support for better stability with a more snug fit.
Recommended pairing
This model pairs well with my extruder-mounted extruder cable support.
Printing
This prints with no supports and no special instructions.
Installation
Note: The original model installs on the front side of the extruder cable. This model is the opposite and installs on the back side of the extruder cable, facing away from the printer.
First, turn off your printer. Open the mainboard case by removing the screw on the rear.
Then, continue the installation with these instructions:
 | Photo of opened mainboard box |
 | Insert the printed support into the cable lip with the grooves facing the rear of the box |
 | Photo of support correctly inserted |
 | Holding the extruder cable next to the support, thread a zip tie through the mainboard box lip holes, around the support and cable, and bath through the opposite hole |
 | Fasten the zip tie |
 | Close the mainboard box and re-install the screw |
 | Attach a second zip tie around the support and extruder cable using the upper notches on the support. Trim the zip ties excess. All done! |