HexiBox Series: Dayton TCP115-4 7th Order Bandpass Subwoofer remix: for smaller printer and different mating
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I forgot speaker terminals! I'll drill them in manually... Finished! but, I think 8" sealed sub would be better
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 236
- Makes
- 1
- Views
- 2,964
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Intention to print these 4 parts and then use ½inch nominal (0.472 in) plywood for top and bottom. To use threaded rod (¼-20 or similar, those are 6.5mm holes) to clamp shut
I'm finding 400-800g per part, so this is a plastic hog…
I'm doing 0.6mm nozzle, 3 perimeters, 40% infill…
I'm assuming to use “rope caulk” for sealing between plastic to plywood on the open side… though if this doesn't work well enough maybe I'll have to make a little stubby mating side. For the closed side, the 1mm thickness intention is just air sealing. The structure will be handled by plywood there also.
I'll measure the frequency response when I get it together…
12/24 updated for 6.5mm through holes (better fit ¼-20 threaded rod) and added/updated speaker blockoff holes for m2 heatsets, added block-off cap part (intention for 8-12mm length allen head m2 fasteners and heatset inserts); added additional through holes for support
12/28: parts printed. Dovetails fit pretty nicely, no problems there. I forgot speaker terminals! I'll drill them in manually, maybe in the top plywood surface…
Oct 2026: Finally finished!
It's...fine. It doesn't hit bass drums to the chest like I'd want from a really good sub
I mean, yea it's low and loud for a 4" woofer, but really I think an 8" sealed box could be the same size and be musically better, and certainly a vented box 8" or better could be louder.