DIMM & SO-DIMM FIX + CLONE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stackable tray for DIMM + SO-DIMM RAM modules.
- Rating
- 4 / 5
- Likes
- 37
- Downloads
- 365
- Makes
- 2
- Views
- 1,212
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
It can hold up to 32 pieces of DIMM and up to 64 pieces of SO-DIMM modules.
If you store modules with heatsink then the capacity may be less than ½.
It's stackable design, but NOT compatible with the original.
Printed from low cost 0.22mm PETG with 25% infill.
Print time in my K1 is about 2 hours and 20 minutes.
These module types will fit easily (tested): SDRAM, DDR, DDR2, DDR3 and DDR4 DIMM and SDRAM, DDR, DDR2 and DDR3 SO-DIMM.
Do not use PLA for this. It's really fragile and may broke just like my prototype printed from PLA. I'm recommending to print from PETG or other material with its properties.