Bambu Lab P1S Magnet Mount Poop Chute/Bin for Spool Use
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a magnetic mount poop chute/bin with clearance for the rear mounted spool.
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 114
- Makes
- 1
- Views
- 1,752
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution
This is a magnetic mount poop chute/bin with clearance for the rear mounted spool.
The bin can be magnetically mounted directly to the back of the printer.
I also created a mount that screws into the chute by replacing the two screws with M3x8mm BHCS. The mount forces the bin to align to the chute. If using the mount there is an additional spacer that gets super glued to the back of the bin so that it sets flush to the back of the printer.
The magnets are 8x2mm and super glued in place. When using the mount ensure the polarity of the magnets on the bin and the mount aligned properly so they don't repel each other.
If using the bin without the mount, glue all 8 magnets in place. If using it with the mount, leave the bottom four out of the bin, glue the spacer over the bottom, and glue the 4 bottom magnets to the spacer.
Prints without supports.