1 / 7
PTFE Tubing Coupler for MMU2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Coupler for the MMU2 PTFE tubes
- Rating
- 5 / 5
- Likes
- 30
- Downloads
- 145
- Makes
- 3
- Views
- 1,537
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
So in making my Lack Enclosure, I cut my PTFE tubes too short. I had to get a few couplers and I tied them back to back and placed them in the middle so it would extend and get my tubes down to my lower cabinet.
The filament catches a little bit as you pass through, but it seems to be working well. I probably should center drill the upper PTFE tubes in case that is where the filament catches, but I didn't and it's been working well enough.
Simple enough print and concept, it uses the M6-1 thread for the couplers.