1 / 3
Ender 3 V3 SE Lighter Fan Shrouds — image 1
1 / 3

Ender 3 V3 SE Lighter Fan Shrouds

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€0.64 – €0.78 net (excluding VAT)

For file: Ender 3 V3 SE Superlight Fan Shroud with Air Duct-Ender-3 V3 SE_0.4_CR-PLA_45m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €0.71 excluding VAT (range midpoint).

Weight reported by the author
8 g
Print time reported by the author
45 min
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

Takes a light fan shroud and makes it even lighter.

Rating
4.818 / 5
Likes
153
Downloads
1,667
Makes
13
Views
6,643
Reviews
11

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

3rd photo shows how it should be laid out. Takes similar inspiration from another shroud, but is designed around the shroud being remixed. Supports aren't needed, but it may look nicer if printed with ironed supports. If you're looking for a 2150 to 4010 fan shroud that pairs well with this, you can find it on my profile or here.

Instructions:

Step 1: On the old fan shroud, remove the three screws holding it on (one is on the left and two are on the right) and pull off the stock shroud.

Step 2: With the stock shroud removed, screw in the screw on the left into its slot for safekeeping (not required but recommended). Remove the 4 Phillips screws for the fan and remove the old air duct.

Step 3: Slot in the new duct. With the 4 Philips screws from earlier, have the fan placed on it (with the duct facing the bottom of your new shroud). 

Step 4: Line up the screw holes with the old screw holes on the extruder. Use the two screws from earlier to screw it in.

And it’s in! Enjoy your new shroud!

Tags