Sewing needle magnet holder
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.28 – €0.34 net (excluding VAT)
For file: X Magnet for needles_0.4n_0.2mm_PLA_MINIIS_12m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.31 excluding VAT (range midpoint).
- Weight reported by the author
- 6 g
- Print time reported by the author
- 12.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A very simple holding base for flat magnet to keep needles from getting lost.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 227
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Public Domain
My wife started to use old, flat magnets that were previously attached to the back of shopping lists from the fridge as a means of keeping loose pins, sewing needles etc from getting lost down the side of the chair or on her workbench. I immediately saw a place for a simple 3d print to hold the magnet and make it look more ‘bought’. Such a simple design in Tinkercad which took only a couple of minutes to make. My intention was to use double sided tape to hold the magnet in place, but the fit was so accurate that the magnet is firmly held in place without the need.
Input shaping (which I think is a big plus) makes it such a quick print.
Using old magnets in this way was very eco friendly I thought, even though I have various sizes of magnetic tape on a roll which I could have also used had I have come up with her idea.