Collapsing lightsaber with holster and stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lightsaber with 4 different grip options
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 59
- Makes
- 1
- Views
- 647
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution
About 36” long when extended and 8.5” when collapsed.
There are 4 magnets around the tip and one on the holster to hold it and be able to draw and extend the blade. HOWEVER: the magnet is NOT strong enough to hold the lightsaber while walking around.
All pieces were printed in PLA at .2, 20% infill and no supports. The blades will need a 5mm brim to help hold them and are printed in vase mode using a .6 nozzle and a line width of .72. This makes the blade much less fragile.
The lightsaber will sit on the stand with or without the holster on it, but overbalances with the blade fully extended.
The magnets used are 10x30x3mm and would not be necessary if you don’t want to play with the holster.
