FingerGearFidget (2 Gears)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.45 – €2.99 net (excluding VAT)
For file: CE3E3V2_9R.FingerFidGearAssy.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.72 excluding VAT (range midpoint).
- Weight reported by the author
- 24 g
- Print time reported by the author
- 3.2 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Your thumb drives a large spur gear that drives a smaller gear with a clicker.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 21
- Makes
- 0
- Views
- 193
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
I enjoy working with gears and put two spur gears together with a ratchet and a finger ring to make this fidget. The larger gear rotates the smaller gear at 5X faster.
The finger ring is a press fit into the base.
Using the Fusion 360 spur gear script to design the gears was pretty simple after a couple of trial and errors.
I used the recent finger tweezer design to help install the retainer rings on the shafts because the retainers are so small.
The clearance between the ring base and the gear base is 0.2 mm. I found that the 0.175 mm clearance was too tight.
I used a 0.3 mm for the shaft to gear clearance.