Table Leg Foot Generator (OpenSCAD)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Create a foot/tip/cap for a table/chair/stool leg.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 119
- Makes
- 0
- Views
- 467
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a completely customizable generator for making feet for furniture legs. Use the Customizer in OpenSCAD to set options and sizes.
Creation Notes
The included print file is what I created this for. It is a little unusual in that I needed to raise the table up slightly.
I set the upper inside diameter at slightly wider than the lower inside diameter so I could get a snug fit but still get the foot started sliding on. I expected that if I could not push it all the way on, the weight of the table would do that.
Printing Note
I did not want to waste the time and material to print the entire thing with sold infill, but I needed it to be sturdy. So, I set the perimeters to 5 to create a solid outer ring under the leg pipe, and used standard infill for the center section where there is no need for load bearing.