Hoverboard Charging Port Cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple cap to protect your charging port from dust and debris.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 39
- Makes
- 0
- Views
- 156
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This was designed for a Hover-1 Titan, but I suspect that it will fit most charging ports.
Printed on Ender 3 V2 with Direct Drive extruder and Micro Swiss hotend
Material: PolyMaker TPU95 (You need a squishy material for this to work)
Layer height: 0.2
Speed: 15 for everything (It prints in under 9 minutes)
No supports
Infill: 15% Grid
Top shell layers: 2
Bottom shell layers: 2
The open ring simply slips down over the thread of the port connector. The cap should fit snuggly around the connector leaving a small loop of the strap exposed. This makes it easy to remove the cap for charging.