Prusa MK4 Cooling Fan Shroud
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.49 – €0.60 net (excluding VAT)
For file: P3D MK4 Fan Scoop_0.4n_0.15mm_PLA_MK4IS_35m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.55 excluding VAT (range midpoint).
- Weight reported by the author
- 6 g
- Print time reported by the author
- 35.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
MK4 cooling fan shroud to keep your cooling fan clean.
- Rating
- 5 / 5
- Likes
- 35
- Downloads
- 175
- Makes
- 8
- Views
- 1,860
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Here is an MK4 cooling fan shroud designed to help keep your cooling fan clean.
(VH fans, see challenge below)
You can use it as;
1. a shroud by itself
2. a shroud with a grill
3. a shroud with the grill and a filter media installed like a carbon mesh. (The carbon mesh will be placed in front of the grill, not between the grill and the fan blades.)
The grill is located slightly away from the fan to reduce noise.
The grill is printed separately and installed in the fan shroud after printing. You have 3 choices for the grill, you can use the honeycomb or the spiral grill provided. We also included a step file of a blank grill that you can use to design your own grill pattern. You can also use it as a template to cut out the carbon mesh. When printing the grill, make sure the 3 dots are facing up. When you install the grill, make sure the dots are facing down or towards the Nextruder and fan. There is a locking tab on the inside of the shroud to hold the grill in place. Use your thumb to carefully press it in place.
Finally, if you are not planning on using any filter media, like the carbon mesh, you can carefully snap off the top of the shroud at the 3D printed seam lines to reduce weight and increase air flow into the fan.
Print a few of these to customize your MK4 printer for different materials. If this works for you, please give it a like or even post a make. -enjoy
-Printium 3D
Challenge;
Rockers, can you use the included blank .step file to create a really cool VH or EVH grill? Please post your makes.
Printed on the MK4
PLA or PETG (we used PLA)
.4 mm nozzle
.15 layer height
No supports
No raft or brim
Be sure to check out our other designs.