Headphone desk or shelf hanger with extra hook
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hang your headphones off the side of your desk or shelf, out of the way.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 54
- Makes
- 0
- Views
- 271
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Share Alike
Update 2026-06-13:
Added an adapted model for a shelf (hangs perpendicular to the edge). Will work for shelves up to 13mm thick.
Inspired by
Made to screw-clamp onto a desk, and added extra hook at the bottom.
Designed for a desktop 25mm thick but the screw should accommodate down to about half of that.
Designed for headphones, diameter ~150mm and 25mm wide but there is some margin for larger or smaller (see photos).
Designed for 0.3mm tolerance (25.3mm clamp and 0.3mm smaller screw than the hole). This should work for most, but if the screw is too tight then shrink the screw 1-3% in your slicer and try again.
Printed with 0.2mm layer height; 3 wall loops; and 15% cubic infill. Use triangle infill on the screw for a stronger screw.
Use supports from build-plate only; and max 20% threshold angle to avoid printing unnecessary supports. I only needed supports under the part that fits over the desktop (see screenshot).
The screw-hole is tear-shaped so it can be printed upright (notch upwards) without the top of the hole sagging and constricting the screw (maker's muse tip).
Have fun!