1 / 2
Prusa XL Side Filament Sensor with Magnetic Breakaway Parts and PTFE Fittings — image 1
1 / 2

Prusa XL Side Filament Sensor with Magnetic Breakaway Parts and PTFE Fittings

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This version of the Prusa XL Side Filament Sensor has breakaway fittings, allowing it to be tubed directly to a drybox.

Rating
0 / 5
Likes
14
Downloads
46
Makes
0
Views
1,219
Reviews
0

Updated at source:

Model information

License
GNU General Public License v2.0

This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting held in place by magnets.

I made this mod because I was tired of the PTFE tubes popping out the back of the official sensor blocks. I also wanted to connect my PTFE tubes directly to my drybox and still be able to remove filament when the spool ran out.

I used these PC4-M10 fittings off Amazon, chosen because of their thread depth, beveled edges, and collet thickness. You can fit the whole fitting inside a 10mm socket.

https://www.amazon.com/gp/product/B086W9HZDK

I used this 10mm socket to install the fittings. It has just the right amount of thickness to allow it to tighten an inner fitting.

https://www.amazon.com/gp/product/B09BTNVVVW

This design used 5mm x 5mm cylindrical magnets. The magnets are press-fit. The design has small holes on the back to allow magnets to be removed.

https://www.amazon.com/Personalized-Multi-Use-Whiteboard-Bulletin-Refrigerators/dp/B075PNR4W5

I finished off the design with some collet clips to make sure the PTFE tubes would stay in place.

https://www.amazon.com/gp/product/B0BCJ4JCCR

Tags