1 / 5
Genovation ControlPad CP24 Riser
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple riser that mounts to the back of a Genovation ControlPad CP24.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 18
- Makes
- 0
- Views
- 254
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
This riser adds 7° of tilt bringing the total angle to 17°.
What you need is:
- 2 #8-32 ½" screws
- 1 #8-32 Nut (I used a nylon locking nut)
- 1 #8 Washer
- 1 Mini Glue Stick (5/16") for anti-slip
First embed the glue stick. Cut it to length, slightly melt one half with a flame and press into the recess.
To install, carefully unscrew the case sliding the front up and off, remove the board, screw the top in first into the brass insert, then use the nut, washer on the inside, and screw to secure through the mounting cutout; Then reassemble. You may be able to do this without disassembly.