1 / 1
Anycubic Kobra Neo PFTE/Bowden Top Guide
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Guide for PFTE tubing from spool that is lower than the top of the printer.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 35
- Makes
- 0
- Views
- 461
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
You will likely have to take a small bit to open up the hole on the bottom and for the screws. I had to change the OEM M5 screws that Anycubic used and use 2 M5 30mm screws instead to make it all fit.
Infill - 40%
Layer Height - 0.3mm (could do 0.2mm for aesthetic)
No supports needed!