1 / 1
Mario Qwirkle - Single Color Printers
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Took the files made by nathanmfast and threw it in a slicer and organized it for a full set of a single color.
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 58
- Makes
- 1
- Views
- 312
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Share Alike
This 3mf file was sliced in BambuSlicer. Turn off the tiles and print just the symbols. Then make sure you keep your bed warm and keep the symbols on the print bed. Next start the print again with just the tiles. Make sure your zhop is setup properly. (I'd say aprox .8mm zhop is good but your mileage may vary.)If your printer is fast or hot it might be fine even if the zhop is off as any scraping of the symbol wont be visible