Cobra Hood Ornament

OK, this one is just purely for fun. I made a Cobra hotend enclosure decoration for my Anycubic Kobra 3d printers. This is a 2 piece build there is the cobra and a mounting bracket. For the cobra I used Amolen glow in the dark PLA. and then PLA to match the enclosure for the bracket. The cobra was harder to print in that the glow in the dark filament required higher heat and slower speed to get a good print, 40 mm/s. So for it the nozzle, the temp was 220 degrees and the bed temp was 75 degrees. For the bracket the usual 195-200 nozzle temp works fine and 65 on the bed temp. To print this one, use supports and lay the cobra on its back for printing. I found that I needed to adjust the estep for the Amolen filament as it did not flow as smooth as regular PLA. It seems to be more abrasive than other filaments.