1 / 1
Foldable and ease to print / assemble phone stand — image 1

Foldable and ease to print / assemble phone stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ease to print, no screws needed, foldable

Rating
4 / 5
Likes
15
Downloads
166
Makes
2
Views
610
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted something compact, simple to make, and then I removed the magnets' holes, added a short pin and resized the hole in the other part so that you can just push one part into the other. I don't know if it will become loose after some time, but right after printing it's pretty nice.

The original size can be a bit unstable for larger phones in vertical position. You can resize in your slicer, maybe by 15%, and with circa 10 cm lenght, it became much better for me.

I printed this one in PLA from Tecbears, using a Sovol SV07 Plus, Cura slicer, 200 degrees, 75 degrees bed temperature, no brim, no supports. Other configurations I used: 0.3mm (extra fast); speed 240 mm/s; acceleration 6000 mm2/s; fan speed 30%; infill pattern: grid; 15% infill density. 

 

Tags