Lid for DIY Print bed filament dryer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3D printed lid (D210mm x H125mm) for DIY Print bed filament dryer with vent and air intake/cable outlet holes
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 107
- Makes
- 0
- Views
- 701
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
New model to complement the DIY Print bed filament dryer from Leftcetio but can also be used without (drying will just take a bit longer).
Added staggered air in- and outlets to let moist hot air escape and fresh air to take its place.
Diameter 210mm (1.2mm walls), height 125mm.
Print in the picture is printed with ASA to be able to dry Nylon filament at high temperature but can be printed with any temperature resistant material (depending on your required drying temperature).
Can be printed without supports
Link to the design in Onshape (you can copy and edit if needed)