1 / 4
Multiboard Multigrid Tabbed Label Extension Lids - Snap On, Stackable
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gridfinity style 0.25 Unit tall extension lids for the Multigrid that have tabs to be able to stick on / write labels on
- Rating
- 4 / 5
- Likes
- 17
- Downloads
- 48
- Makes
- 1
- Views
- 528
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Gridfinity style 0.25 Unit tall extension lids that have tabs to be able to stick on / write labels onto.
These lids are stackable and snap onto the bins itself no extra hardware or post processing required.
The tolerances are going to be a bit tight no these, so adjust your flow accordingly,
- If it's too tight try lowering your flow by 1% - 2%
- If Top surface starts under extruding after adjusting flow, try raising the top surface flow to compensate
Can be printed without any supports
I personally only use the minimal amount of filament for these lids as they aren't structural.
1 Perimeter Walls, 5% Gyroid Infill, No Supports
- These settings are good enough for my use case, but if you're going to put any significant amount of weight on top of the lids I reccomend using the standard reccommended settings for Multiboard at:
- 3 Perimeters
- 15% infill