1 / 2
COMMON GARDEN HERBS STAKE LABELS  HOLLOW LETTERS — image 1
1 / 2

COMMON GARDEN HERBS STAKE LABELS HOLLOW LETTERS

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€2.97 – €3.63 net (excluding VAT)

For file: CE3S1_herbs.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €3.30 excluding VAT (range midpoint).

Weight reported by the author
23 g
Print time reported by the author
4.18 hr
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

20 little stake labels for common garden herbs with hollow letters for single colour filament.

Rating
0 / 5
Likes
12
Downloads
81
Makes
0
Views
615
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

20 Common Herb Stake Labels (Hollow Letters for Single Colour Filament)

Size 135mm X 10mm X 1.0mm

The biggest challenge for these as they will be outdoors will be the heat of the sun. PLA will melt, bend, twist with sufficient heat.

I printed these using PLA and tested them out in my garden. They have worked for me so far in the hot subtropical sun of Brisbane Australia with only a few bending significantly because of the heat. But your local conditions will be different.

So the key points if you are going to make and use these.

  1. Try placing them in the most shady spot.
  2. Stick them in as deeply as you can (without covering the letters) and vertically (rather then at an angle) into the soil.
  3. Increase the thickness in your slicer to 1.6, 1.8, 2.0mm or higher which should reduce any bending.
  4. Finally try using PETG filament which is more resistant to the sun and heat.

REMEMBER If you use PLA and they do bend in the sun you can always bend them back by applying a little bit of heat. You might also not mind if they go a bit twisted, I personally don't mind at all.

Tags