1 / 1
Clip-on wire duct for UHP-200
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A wire duct that clips onto the top of a Mean Well UHP-200 power supply.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 39
- Makes
- 1
- Views
- 315
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- GNU General Public License v3.0
I designed this since I wanted to run some wires across the top of a UHP-200.
Print notes
- Recommended material: ABS/ASA. Low creep material (not PLA/PETG/PA) is recommended to maintain clamping force. No shrinkage compensation needed for ABS.
- Layer height: 0.2mm
- Perimeter width: 0.4mm
- Minimum 2 perimeters and 4 top/bottom solid layers.
- No supports are needed, but makes use of bridges. Thin features on the first layer may benefit from a brim if bed adhesion is an issue.