1/24 FWD RC Chassis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3d printable Chassis to Motorize 1:24 model cars
- Rating
- 0 / 5
- Likes
- 76
- Downloads
- 462
- Makes
- 0
- Views
- 4,752
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello All,
After 3 iterations I'm proud to share my chassis.
I wanted to create a true FWD Chassis for my 1:24 Honda Civic Model, but I also wanted to make the chassis modular. So with a different chassis plate i could also make an Midmotor or Rear Motor variant. I wanted my chassis to have suspension.
I took inspiration from the “Make it RC” Youtube channel. As the servomounts are taken from the UC1 chassis and are his design.
The prototyp isn't the fastest for now and you could say it's scale speed. See Video here.
Added a new Speed Gearbox as a Remix. Please also refer to it also as a Manual to assemble the Motormount.
Needed Hardware:
For Motormount refer here
2 850 Bearings (Bearings for the Spool)
10 Ballbearings 682ZZ 2 x 5 x 2 mm (8 For Hubs, 2 for Motormount)
1,5mm Rod Cut to lenght for Suspension
16 M1.6 6mm Screws for Mounting Bulkheads to Chassis and Shocktowers to Bulkheads
M2 Screws and Nuts used for Hubs, fixing Outdrives to Spool, Axles and Wheelhubs
Springs from Ballpoint pens cut to lenght
For Driveshaft you have to make sure there is free movement and clearance (I ground done some M1.6 screws but i would recommend M1.6 grubscrews or rod). Superglue on the Outdrives is highly recommended, but be careful!
Printing Advice:
The Oudrives and the Driveshafts should be printed seperatly in higher detail (I printed them in 0.1 with the 0.2 Nozzle)
The Rest of the Chassis i did print in 0.2.
Please share your Feedback if you build it.
Greetings