1 / 2
Kirby Amiibo Display Base Remastered
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remade the original display base from scratch to improve smoothness and tweak design.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 26
- Makes
- 1
- Views
- 151
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed with the following settings:
- 3 perimeters
- 4 top and bottom layers
- .2 layer height
- .4 nozzle
- Yoyi Transparent Yellow PLA
- 10% Triangle Infill
- Seams aligned to rear. I oriented the model in SuperSlicer so that the seam was in the back of my intended display position.
The above settings resulted in the pictured print. It took around 17 hours and used 300g of filament. Time will vary based on speeds and acceleration settings.
Overall size: XY: 178mm, Z:166mm
Make sure you have well tuned temps and 1st layer adhesion as the size of the base makes it prone to early warping.