1 / 1
Rocktopus V2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
A remix of the Rocktopus by UNION3DPRINTING. Improved quality over the original Rocktopus. I've smoothed out the seams between where the head and body connects, resulting in a better looking print.
Supports are recommended under the chin. The hole in the body prints fine without supports, but for a clean print I recommend them. Supports aren't needed for the arms.
The print should stick fine to a heated build plate, so no brim in required. If you do decide to print with a brim, then good luck cleaning your print up!
Print recommendations:
.2 mm layer height
15% infill or higher
Brim: No
Rafts: No
Skirt: Doesn't matter.