New type of bowden connector for Snapmaker J1/J1s
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lets you switch filament without removing the lid and bowden tube
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 101
- Makes
- 2
- Views
- 808
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
WARNING: Don't use it without the bowden tube being attached because the connector can rotate and bump into the LED strip when homing.
NEWS: I've attached a version 2 (june 2024) that lets you bypass the bowden tube without ever having to remove it.
This connector has following advantages over the stock connector:
- Lets you switch filament without having to remove the printer lid or bowden tube
- Has a larger curve radius to decrease drag (measured to 77 grams vs 122 for white glossy PLA and 92 vs 157 for black matte PLA) once it has been feeded through and is gliding
- Doesn't make the bowden tube scrape against the lid
- No need for the small piece of clear rubber hose anymore
- No need to remove the bowden tube if you want to bypass it (version 2 only)
Print this at a very fine quality (slow and 0.16 layers). I have attached a screen shot of default Luban settings that are confirmed to work.
Pause the print just before the small lip (see arrow on photo) and put on the ball bearings.
Insert the bowden tube until it bottoms out completely and tighten an M4 screw a bit to secure it.
If the filament jams when pushing it through, it's probably because the bowden tube isn't fully inserted. There can be some crumbs inside the connector - try and clean it or print with larger retractions.
Version 2 can be a bit finicky to get working, so if it fails you may try version 1 which is still a big improvement over the stock version.
Fusion 360 source included.