1 / 2
Gamecube Memory Card Flap
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The memory card flap from the Nintendo Gamecube console
- Rating
- 5 / 5
- Likes
- 35
- Downloads
- 370
- Makes
- 3
- Views
- 787
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution
This was modeled to the original Gamecube design. It may not be the easiest to print because of that.
I printed with the shaft vertical as I wanted this to snap into the original location and revolve freely. Supports were used with a 0.08mm layer height.
I had to trim the two stoppers on each side as they were interfering and preventing the flap closing properly. I modified this model so these are slightly narrower, but if you notice them getting stuck, they might need trimming.